NETGEAR 700 Series Managed Switch for Software v2.1 - Manual (Page 113)

700 Series Managed Switch User’s Guide for Software v2.1
Command Line Interface 6-23
SM-10004-02
Name
Use the name command to give a name to the switch. This is done to make the switch easier to
identify.
Syntax
FSM726(config)# snmp-server name <switch name>
Where
<switch name> = the name you wish to give to the switch
Host
The host command is used to specify hosts to receive SNMP notifications.
Syntax
FSM726(config)# snmp-server host <host name> <host IP address> <community string>
Where
<host name> = the name of the host that is to receive SNMP notifications.
<host IP address> = The IP address of the host specified
<community string> = the community which the host belongs to
Host Authorization
The host-authorization command enables SNMP host authorization.
Syntax
FSM726(config)# snmp-server host-authorization
Trap
The trap command enables SNMP trap. s IP is not in the SNMP host table.
Syntax
FSM726(config)# snmp-server trap