NETGEAR 700 Series Managed Switch for Software v2.1 - Manual (Page 116)

700 Series Managed Switch User’s Guide for Software v2.1
6-26 Command Line Interface
SM-10004-02
FSM726(config)# system config-tftp ip <IP address>
Where
<IP address> = the IP address of the TFTP server.
Config-tftp Path/File
The config-tftp path/file command lets you configure the path and the filename of the
configuration file to be loaded/saved.
Syntax
FSM726(config)# system config-tftp path/file <path&filename>
Where
<path&filename> = the path and the filename of the file
IP
The IP command lets you set the IP address of the switch.
Syntax
FSM726(config)# system ip <IP address>
Where
<IP address> = the IP address of the switch.
IP-Filter
The purpose of IP filtering is to prevent unauthorized personnel from gaining access to the switch.
This is accomplished by allowing only certain IP addresses to be able to access the management.
This command enables IP filtering on the switch. The No command will disable it.
Syntax
FSM726(config)# system ip-filter