NETGEAR 700 Series Managed Switch for Software v2.1 - Manual (Page 117)

700 Series Managed Switch User’s Guide for Software v2.1
Command Line Interface 6-27
SM-10004-02
IP-filter address
The IP-filter address allows you to enter and remove IP address from the approved list. Use
the No command to remove an IP address.
Syntax
FSM726(config)# system ip-filter address <IP-address>
Where
<IP address> = an IP address that is authorized to access the management.
IP-Mode
The I P-Mode command sets the IP assignment mode of the switch. There are three modes
available to the user.
Manual – The user manually enter IP related information
BootP – Bootstrap Protocol, which allows the FSM726 switch to discover its own IP address from
a BootP server on the network
DHCP – The switch accepts DHCP broadcast from a DHCP server and automatically configure IP
related information
Syntax
FSM726(config)# system ip-mode [manual | bootp | DHCP]
Mask
Use the Mask command to set the network mask.
Syntax
FSM726(config)# system mask <network mask>
Where
<network mask> = network mask of your network
Gateway
Use the Gateway command to set the default gateway