NETGEAR 700 Series Managed Switch for Software v2.1 - Manual (Page 30)

700 Series Managed Switch User’s Guide for Software v2.1
4-10 Administration Console Telnet Interface
SM-10004-02
Gigabit Ports. For the gigabit ports on each switch, the port type may be chosen. The default is
that the port uses the RJ-45 interface (GT). You can select the GBIC interface (GB) by switching
the port type from ‘GT’ to ‘GB’. This can be done by hitting the space bar when the cursor is on
the port number.
Note: enabling the GBIC connector for a Gigabit Ethernet port disables the built-in 1000BASE-T
port. GBIC ports do not support Auto Negotiation. You must manually configure the GBIC port.
The default values are 1000 Mbps, full duplex.
Main Menu> Set-Up> GBIC
On this page, you can set up the port characteristics related to GBIC or copper media.
Figure 4-13: GBIC Port Configuration
All of the parameters on this page are toggle settings. To change, or toggle, between options, hit
Ctrl-M to move the curser to the ports field and simply strike the space bar when the appropriate
option is highlighted.
Main Menu> Tools
These system tools are provided:
• Save Configuration to NVRAM
• Restore Factory Values
• Reset Switch