NETGEAR 700 Series Managed Switch for Software v2.1 - Manual (Page 61)

700 Series Managed Switch User’s Guide for Software v2.1
Web-Based Management Interface 5-11
SM-10004-02
• Link: A green triangle pointing up indicates a valid link, while a red triangle
pointing down indicates no link.
• On/Off: Indicates if the port is enabled or disabled by the Administrator.
• State: This refers to the Spanning Tree state of the port. Ports will be Blocking
(Blk), Listening (Lis), Learning (Lrn), Forwarding (Fwd) or Disabled (Dis).
• Speed: Indicates the speed and duplex for the port. The possible entries are
Auto-negotiation (Auto); 10 Mbps half duplex (10M Half); 10 Mbps full
duplex (10M Full); 100 Mbps half duplex (100M Half); or 100 Mbps full
duplex (100M Full).
• Flow Control: Indicates whether Flow Control support is set for automatic (Auto) or off
(Disabled)
• Priority Indicates if the port is set to high priority or normalpriority. This is an
advanced feature that is configured under Traffic Prioritization
• Trunk ID Indicates if the port is a member of a trunk by showing the ID number of the
trunk. This is an advanced feature that is configured under Port Trunking
Status > MAC Address Table
Figure 5-10: MAC Address Table
The MAC Address Table is a dynamic address lookup table that allows you to view the dynamic
MAC addresses that are currently in the address database. When a MAC address is in the database,
the packets intended for that address are forwarded directly to that port. You can filter the
displayed addresses by port, VLAN, and/or MAC address by checking those fields.