NETGEAR 700 Series Managed Switch for Software v2.1 - Manual (Page 93)

700 Series Managed Switch User’s Guide for Software v2.1
Command Line Interface 6-3
SM-10004-02
<IP Address> = the IP address of the destination host
Exit
The exit command moves you up one level in the CLI structure. For example, when you are in
configuration mode, and the prompt looks like FSM726(config)# . By entering exit at the
prompt, you will exit the configuration mode and be taken back to the root level, where the prompt
looks like
FSM726# . When you enter the exit command at the root level, you will return to the
CMI.
Syntax
FSM726# exit
Show
You can use the show command to view system configuration. The information that can be shown
falls into the following categories:
• DiffServ – DiffServ settings
• Interfaces – Interface status & configuration
• IP – IP information
• Mac-address-table – the MAC address table and other related items, such as aging timers and
static addresses
• Mirror – Mirroring settings
• Multimedia – IGMP settings
• Running Config – Current operating configuration
• SNMP – SNMP related information
• Spanning-Tree – the Spanning Tree topology
• System – System-related settings
• Trunking – Trunking information
• VLAN – VLAN information
DiffServ
Use the show diffserv command to view the priority associated with each DSCP value.
Syntax