New Media Technology Omnia ONE Multicast - Manual (Page 42)

Allows a +/-3dB adjustment of the right digital audio channel gain to correct minor left/right
balance problems in the input audio. The left channel digital input gain is not affected by this
control and is set using the master AES Level control previously described.
Invert
Permits audio phase inversion to be performed in the following combinations:
[None] –
No Channel inversion is performed (factory default)
[Both] – Both left and right channel phase is inverted.
“Both” is typically selected if it sounds “better” to an announcer (monitoring themselves in
headphones using the output of the processing) than “None”. One of the two settings should. The
goal is to make the relative phase of the headphone feed more in phase with the announcer’s own
bone conduction. Once set, this setting should remain the same for all announcers using the same
headphone feed.
[L] – Only the left channel phase is inverted.
[R] – O
nly the right channel phase is inverted.
These settings are present as a convenience to correct 180-degree stereo phase errors in the input
audio to the processor or in another device after the processor.
Mono Mode
Allows input signal routing to be reconfigured as follows:
[STEREO]
Factory default. Left and Right input channels are routed to the left and right inputs to the
DSP processing chain.
[Mono L]
Configures the DSP processing chain to have both the Left and Right internal channels
fed only from the Left Channel of the input source selected. Note that this selection is
active in all sources selected as Primary and Secondary (Failover) audio sources.
[Mono R]
Configures the DSP processing chain to have both the Left and Right internal channels
fed only from the Right Channel of the input source selected. Note that this selection is
active in all sources selected as Primary and Secondary (Failover) audio sources.
[Mono L+R]
Configures the DSP processing chain to have both the Left and Right internal channels
fed from the sum of the Left Channel and Right Channels of the input source selected.
Note that this selection is active in all sources selected as Primary and Secondary
(Failover) audio sources.
[SWAP]
OmniaONE Multicast - Use and Operation Manual – Version 0.90
42