New Media Technology Omnia ONE Multicast - Manual (Page 43)

Configures the DSP processing chain to swap the Left and Right internal channels, that
is, the DSP Left Channel is fed from Right Channel input and the DSP Right Channel is
fed from the Left Channel input. Note that this selection is active in all sources selected
as Primary and Secondary (Failover) audio sources.
<-Exit
Click on this option to return to the Input/Output submenu.
Output
There are five controls under the heading “Output” and each will be explained in the order in which they appear
in the menu:
<-Exit
Click on this option to return to the Input/Output submenu
Anlg Level (Analog Level)
Adjusts the master audio Output level for the analog outputs which appear on the rear panel XLR
male connectors. This control adjusts both the left and right stereo channel simultaneously.
Right Trim
Allows a +/-3dB adjustment of the right analog audio channel gain to correct minor left/right
balance problems in equipment following the OmniaONE. The left channel output gain is not
affected by this control and is set using the master Analog Level control previously described.
AES Level (AES/EBU Level)
Adjusts the master audio Output level for the AES Digital Output which appears on the rear panel
RJ-45 StudioHUB
®
connector.
Right Trim
Allows a +/-3dB adjustment of the right digital audio channel gain to correct minor left/right
balance problems in equipment following the OmniaONE. The left channel output gain is not
affected by this control and is set using the master AES Level control previously described.
Samp. Rate (Sample Rate)
Configures the Output Sample Rate. Options are as follows:
[48k]
Slaves the output sample rate to the Omnia’s internal 48kHz sample clock. To use output
sample rates other than 48 kHz, Input or External sync must be used.
[Input]
Slaves the output sample rate to the sample rate present on the Omnia’s AES
digital input. Synchronization is possible over a range of sample rates from 32kHz to
96kHz.
[Ext] (External)
OmniaONE Multicast - Use and Operation Manual – Version 0.90
43