NetComm IG6000 - Manual (Page 15)

Industrial Modem User Guide
YML391­3A 15
M4 Speaker on during dial, answer, retrain or rate change
O1 Enter On­line state and force communication retrain (V.22bis and V.32bis only)
O2 Retrain, donÕt go on­line (V.22bis & V.32bis)
O3 Change line speed to 4800 bps (V.32 & V.32bis)
O4 Change line speed to 7200 bps (V.32 & V.32bis)
O5 Change line speed to 9600 bps (V.32 & V.32bis)
O6 Change line speed to 12000 bps (V.32 & V.32bis)
O7 Change line speed to 14400 bps (V.32 & V.32bis)
P Pulse dialling
Q0 n Modem returns response codes
Q1 Modem does not return response codes
Q2 Modem does not return RINGING or response codes when answering
R9 9600 bps (locked terminal speed ­ no autobaud)
R14 14,400 bps (locked terminal speed ­ no autobaud)
R19 19,200 bps (locked terminal speed ­ no autobaud)
R28 28,800 bps (locked terminal speed ­ no autobaud)
R38 38,400 bps (locked terminal speed ­ no autobaud)
R57 57,600 bps (locked terminal speed ­ no autobaud)
R115 115,200 bps (locked terminal speed ­ no autobaud)
R230 230,400 bps (locked terminal speed ­ no autobaud)
Sn? Display value in S Register ÔnÕ
Sn=x Place ÔxÕ in S Register ÔnÕ
T n Tone dialling
V0 Numeric response codes
V1 n Verbal response codes
W0 CONNECT message reports the terminal speed
W1 CONNECT message reports the terminal speed
W2 n CONNECT message reports the line speed
X0 Basic response codes (codes 0­4,8)
X1 Extended response codes (codes 0­5,8,10­12,30­40,60­62)
X2 Extended response codes (codes 0­6,8,10­12,30­40,60­62)
X3 Extended response codes (codes 0­5,7,8,10­12,30­40,60­62)
X4 Extended response codes (codes 0­7,10­12,30­40,60­62)
X5 n Extended response codes (codes 0­7,10­13,30­40,60­62)
X6 Extended response codes (codes 0­5,7­8,10­13,30­40,60­62)
Zn Restore configuration profile n (n=0,1,2,3)
&B0 8 bit character length
&B1 9 bit character length
&B2 10 bit character length
&B3 11 bit character length
&B4 n 10 or 11 bit character length determined by autobaud
&C0 DCD signal always asserted
&C1 n DCD signal responds to remote modem
&C2 DCD signal always on, pulses low on disconnect
&C3 DCD asserted during voice session
&D0 Ignore DTR
&D1 Return to Local command state if DTR goes low
&D2 n Hangup & return to Local Com if DTR goes low, disable auto­answer until DTR
asserted
&D3 Initialise with values in &Y profile if DTR goes low
&F0 Restore factory defaults