Napco Security Technologies GEM-DXRP3 - Manual (Page 6)

6
S E T T I N G T H E AL AR M ( AR M I N G ) W H E N L E AV I N G
Arming the System
1. Check the keypad. The green STATUS light must be on in order to arm.
If the green light is off, the number(s) of any unsecured zone(s) will display in
the window. Refer to the pull-up zone list for the location of each problem
zone and secure by closing windows, doors, etc. When all zones are secure,
the green STATUS light will come on.
2. Arm the system. Enter your User Code followed by
D
. The green STATUS
light will go off, the red ARMED light will come on. Note: If you enter an
invalid code, the keypad will beep 4 times, indicating an error. Re-enter your
code.
3. Leave the premises. Leave through the exit door before the exit time expires.
Priority Arming
If you attempt to arm the system with a faulted Zone, a 3-second tone will sound
at the keypad and “P” will display in the window, indicating that the zones must be
secured before the panel can be armed.
Selectively Bypassing Zones
If you cannot locate or repair a faulted zone, it can be removed from the system,
or bypassed. Bypass the zone(s) from the system by pressing
B , followed
by the zone number (or vice versa). The yellow BYPASS light will turn on to
indicate that the zone has been bypassed.
Note: Bypassed zones are unprotected. If a faulted zone cannot be secured,
have the system checked as soon as possible.
12
INTERIOR BYPASS FIRE/TBL SYS TBL CHIME
INTERIOR BYPASS FIRE/TBL SYS TBL CHIME
P
INTERIOR BYPASS FIRE/TBL SYS TBL CHIME