Napco Security Technologies GEM-DXRP3 - Manual (Page 7)

7
S E T T I N G T H E AL AR M ( AR M I N G ) W H E N L E AV I N G
System Trouble If you attempt to arm with the SYS TBL light on, a 3-second tone will
sound and a “P” will display in the window. This indicates that the system has detected
a problem which may prevent it from operating properly. A number corresponding to the
trouble will then appear in the display. Refer to SYSTEM TROUBLE ERROR CODES
for descriptions of these troubles. If you cannot correct the problem immediately, press
C and you will then be able to arm the system in this condition. Note: If you
cannot clear the trouble, have the system checked as soon as possible.
Area Arming (Optional)
In a system that has been partitioned into multiple areas, one or more areas may be armed while others remain disarmed.
Manager's Mode.
The Manager's Mode allows the user to arm / disarm other areas in a partitioned system. To arm a different area:
1. Press the numerical key representing the other area number.
2. Press
G followed by
J
. The keypad will now provide status and control of that area.
3. Enter your code followed by J to arm.
4. Press G followed by
J
to return to the home area.
Global Arming (Optional) (Available only with the GEM-P9600/3200 panels)
To arm all areas simultaneously (including the area you are in), press 9, G and enter your code followed by
D
.
To disarm all areas simultaneously, press 0, G and enter your code followed by
J
.
• The User Code must be valid in all area(s).
• If any zone is not secured, the keypad will display “P”. All faulted zones in the respective area(s) must be secured or
bypassed. Note: If a system trouble is indicated, the system cannot be armed using this method.
P
INTERIOR BYPASS FIRE/TBL SYS TBL CHIME