NETGEAR ADSL Firewall Router DG834 - Manual (Page 31)

Reference Manual for the ADSL Firewall Router DG834
Connecting the Router to the Internet 3-7
202-10005-05, June 2005
c. Connect the Ethernet cable (C) from your DG834’s LAN port to the Ethernet adapter in
your computer.
Figure 3-6: Connecting a computer to the DG834 ADSL router
Note: The DG834 ADSL router incorporates Auto Uplink TM technology. Each Ethernet LAN
port will automatically sense whether the cable plugged into the port should have a 'normal'
connection (for example, connecting to a computer) or an 'uplink' connection (for example,
connecting to a switch or hub). That port will then configure itself to the correct configuration.
This feature also eliminates the need to worry about crossover cables, as Auto Uplink will
accommodate either type of cable to make the right connection.
d. Connect the power adapter to the router and plug it in to a power outlet. Verify the
following:
The power light is lit after turning on the router.
The ADSL link light is solid green, indicating a link has been established to the
ADSL network.
e. Now, turn on your computer. If software usually logs you in to your Internet connection,
do not run that software. Cancel it if it starts automatically. Verify the following:
The local lights are lit for any connected computers.
Ph
o
n
e
DS
L
Lin e
ADSL Firewall Router DG834
C