NDC comm NWH650 - Manual (Page 36)

30 InstantWave High Rate 11Mbps Access Point
From the Filter card, some, all, or none of the protocols listed may be selected for
filtering out:
• IP protocol
• IPX protocol
• NetBEUI protocol
• AppleTalk protocol
• Other protocols
• Internet Multicast Frames
Selecting a protocol to be filtered will activate the AP’s protocol filtering
immediately on clicking OK. Clicking Reset AP is not required. If, after filtering a
protocol, your network is not functioning as before, it’s likely the protocol is
required on the network and you should disable the filter for that protocol.
TFTP:
The Access Point supports remote firmware upgrades using TFTP (Trivial File
Transfer Protocol). You may customize TFTP services with the following options:
Figure 28. AP Setting/TFTP