Napco Security Technologies EXPRESS XP-600 - Manual (Page 15)

Ambush Code - In the event that
you are forced by an intruder to dis-
arm your system, this special code
can be used to disarm the system,
and simultaneously send a silent
alarm to Central Station. If your sys-
tem has the Ambush feature enabled,
the code assigned as the User 6 code
will function as your Ambush Code
Arming / Disarming - Turning the
system on or off by entering your user
code at the keypad.
Auto Interior Bypass - A feature
which allows the system to recognize
when you have not left the premises
and automatically bypass any interior
zones, deactivating devices such as
motion sensors, allowing free move-
ment throughout the premises.
Battery - A backup source of power
to provide protection for a limited
time in the event of a power failure.
Bypass - the manual or automatic
removal of one or more protection
zones from the system. Press
C
and then the zone number to bypass a
zone.
Central Station - Monitors alarm,
emergency and trouble reports from the
alarm system and notifies proper au-
thorities.
Chime - a keypad beep which indi-
cates that a door has been opened while
the system is disarmed.
Easy Exit - Allows an occupant to
leave the premises without disarming
the system. Pressing
A and then
0 while the system is armed will
permit exit by removing the protection
on the Exit/Entry door for 3 minutes,
Exit/Entry Delay - The amount of
time you are allowed to enter and leave
the premises when the system is armed.
Exit/Entry Zone - A zone which will
allow you to enter and leave the
premises when the system is armed.
Instant Protection - Arming without
Entry Delay while remaining on the
premises. (Press A4 while armed)
Keypad Sounder - A local warning
device at the keypad to alert that
Entry delay has started,
System Trouble - A problem has
been detected in the system which
may prevent it from working prop-
erly.
ü üSYSTEM light will be lit.
User Code - A four digit code which
is used to arm and disarm the system
from the keypad.
User 1 Code - A four digit code
which can be used to program, re-
program and erase user codes, as
well as arm and disarm the system
from the keypad.
Zone - An area which is protected
by a security device. Your front door
may be designated as Zone 1, while
the living room motion detector may
be Zone 2. Refer to the Zone Label
on your keypad for the Zone Identifi-
cation of your system.
Glossary
15
Oi218a.pub
page 15 Thursday, December 18, 1997 18:29