Napco Security Technologies EXPRESS XP-600 - Manual (Page 5)

Arming Your System When Leaving
1 Before arming your system, make sure the Green Ready light is ON. This indicates that all of your prot-
ective zones are secure. If any zones are open, the corresponding Zone light will be ON. Secure these
zones before proceeding. If any zones cannot be secured, see Bypassing Zones below.
2 Enter your user code. The Green Ready light will go out, the Red Armed light will light.
•
If you make a mistake entering your code, press B and re-enter the code.
•
If the FIRE light is on, the Fire zone has not been properly reset. Press B and enter the code.
(See Silencing a Fire Alarm, page 8)
3 Leave the premises through the Exit/Entry door. If the keypad gives a steady tone you have taken
too long. Enter your code again to disarm system and then re-enter code and leave.
Easy Arm
The Easy Arm feature allows the system to be armed by simply pressing A followed by 0 .
This will allow the easy arming of the system by someone who is not a regular system user.
Bypassing Zones
If an open zone cannot be immediately fixed it can be left unprotected, or Bypassed, while the rest of the
system is Armed. To Bypass a zone:
1 Press C followed by the zone number to be Bypassed. The Bypassed Zone’s light will flash slowly.
2
Enter your user code. The Green Ready light will go out and the Red Armed light will light.
3 Leave the premises through the Exit/Entry door.
When the system is subsequently disarmed, all bypassed zones will be reset, ready to be armed again.
If it is necessary to bypass any inoperative zone(s), it is important to have the zone(s) repaired as soon as
possible. A bypassed zone does not provide any protection, compromising system security.
Arming Your System
5
FIRE
AC
SYSTEM
READY
ZONE 3
ZONE 1
ZONE 2
ZONE 5
ZONE 6
ZONE 4
ARMED
Oi218a.pub
page 5 Thursday, December 18, 1997 18:29