Napco Security Technologies EXPRESS XP-600 - Manual (Page 8)

Disarming Your System when Returning
1 Enter your premises through the Entry/Exit door. The keypad will sound a steady tone to remind you to
disarm the system before your Entry Delay time expires.
2 Enter your user code. The Red Armed light will go out, indicating that the system has been disarmed.
Note: If you make a mistake entering your code, press the
B key and re-enter the code.
Alarm Indication
If the Red Armed light is flashing rapidly, an alarm occurred while you were away. Proceed with caution!
For your own protection, leave immediately and call authorities from a neighbor’s phone .
Silencing an Alarm
In the event that the system goes into alarm due to a violated burglary zone, the bell or siren will sound and
the keypad sounder will also activate. To silence the system, enter your User code. The zone light of the
zone which went into alarm will continue to flash until B is pressed to reset the alarm memory.
Silencing a Fire Alarm
In the event that the Fire alarm activates due to an violated smoke or fire detector, the bell or siren will
sound a distinct pulsating tone. The Red FIRE light on the keypad will be flashing, and the keypad sounder
will emit a pulsing tone. If a Fire Alarm does occur:
1 If a fire is in progress, evacuate the premises immediately!Call the Fire Department from an outside
phone.
2 If there is no evidence of a fire, enter your User Code. The bell or siren will silence, and the FIRE light on
the keypad will stop flashing but will still be lit.
3 Determine which device went into alarm. If you are protected by smoke detectors, the light on the active
detector will be lit. Once it is determined which smoke detector is in alarm, press B to reset the fire
zone.
4 If the Fire zone has reset properly, the FIRE light on the keypad should go out in approx. 30 seconds
Disarming Your System / Silencing an Alarm
8
FIRE
AC
SYSTEM
READY
ZONE 3
ZONE 1
ZONE 2
ZONE 5
ZONE 6
ZONE 4
ARMED
Oi218a.pub
page 8 Thursday, December 18, 1997 18:29