Nortel Networks NN47230-301 - Manual (Page 11)

Related information 11
italic text Variables in command syntax descriptions. Also
indicates new terms and book titles. Where a variable
is two or more words, the words are connected by an
underscore.
Example: If the command syntax is
show at <valid_route> ,
valid_route is one variable and you substitute one
value for it.
plain Courier
text
Command syntax and system output, for example,
prompts and system messages.
Example: Set Trap Monitor Filters
separator ( > ) Menu paths.
Example: Protocols > IP identifies the IP command
on the Protocols menu.
vertical line ( | ) Options for command keywords and arguments. Enter
only one of the options. Do not type the vertical line
when entering the command.
Example: If the command syntax is
show ip {alerts|routes} , you enter either
show ip alerts or show ip routes , but not
both.
Related information
This section lists information sources that relate to this document.
Publications
Refer to the following publications for information on the Nortel SNA solution:
• Nortel Secure Network Access Solution Guide (320817-A)
• Nortel Secure Network Access Switch 4050 Installation Guide
(320846-A)
• Nortel Secure Network Access Switch 4050 User Guide (320818-A)
• Installing and Using the Security & Routing Element Manager (SREM)
(320199-B)
• Release Notes for Nortel Ethernet Routing Switch 5500 Series, Software
Release 4.3 (217468-B)
• Release Notes for the Ethernet Routing Switch 8300, Software Release
2.2.8 (316811-E)
Nortel Secure Network Access Switch Software Release 1.6.1
Installing and Using Security and Routing Element Manager (SREM)
NN47230-301 02.01 Standard
1.6.1 16 July 2007
Copyright © 2007, Nortel Networks
.