Nortel Networks i2022 Series - Manual (Page 16)

i 2022 ISDN Teleset
14
The Auto-Install programming choices are:
Adjust Contrast – Select Yes or No. The i2022 may display a wait message and start a countdown. This is the T-
Wait timer.
SPID – If the switch supports Auto-SPID you will be prompted to choose a SPID. If your switch does not support
Auto-SPID, press the “Change” softkey and enter the SPID. After entering the SPID press “Save”.
The Teleset will attempt to initialize. If there is a problem the Teleset will prompt you to correct the SPID and/or
switch type.
The Teleset will download its configuration from the switch. If Parameter Downloading is not available, you will be
prompted to program the Teleset manually.
Backlight – Select On, Off, or Dynamic.
Enter the Date and Time.
Adjust the Ring Pattern – Select Yes or No.
Set the 2 nd ring Option – Select Continuous, Partial, or No Ring.
Set the Analog Call Appearance.
Set Primary Call Appearances.
Set an Intercom Key.
Set Speed Dial Keys.
Set the Alarm Clock.
Set a Password.
Set Line Preference.
AUTO-Switch
With Auto-Switch detection, the i2022 determines the type of switch to which you are connected. Should you decide to
manually program the switch type, Auto-Switch detect will tell you if a different type of switch is found. You will then be
given the opportunity to correct the switch type.
AUTO-SPID
Auto-SPID is a National 2 and National 3 ISDN feature. Not all switch types and not all service providers support the Auto-
SPID feature. If Auto-SPID is supported, follow the procedure shown below.
Auto-SPID Procedures
When the countdown timer stops, or is aborted, the Teleset automatically sends the Auto-SPID code to the switch. Upon
receipt of the Auto-SPID code, the switch will download all of the SPID’s that are supported on that line.
NOTE: You may abort the Auto-Install by pressing the Menu key at any time
NOTE: Auto-Install will only run when the i2022 is in the default mode.
NOTE You can abort the T-Wait countdown timer at any time by pressing the Speaker key or any touchtone
keypad digit.
NOTE: To default the i2022 press MENU and enter 91 from the dial keypad. Press the “YES” softkey to complete
the default.
WARNING: DEFAULTING THE i2022 WILL ERASE ALL OF THE MEMORY.
NOTE: If the SPID is not accepted for any reason - including the SPID being used at another location - the phone
displays: “Invalid SPID,” and allows correction of the SPID.