Nortel Networks NN43001-315 - Manual (Page 108)

108 CS 1000 on Linux base
— Initiate an SFTP or Secure Shell (SSH) program.
— Provide the Linux server’s IP address (or host name), the
nortel user ID, and password as parameters.
— Type the put command (for sftp ) or the scopy
command (for scp ) to transfer the patch to the Linux
server.
Note: If you cannot access SFTP or SCP, File Transfer
Protocol (FTP) can be used. FTP can be accessed by invoking
the CLI command
ftpenable , and closed by invoking the
CLI command ftpdisable . The ftpenable command
opens a timed window that closes after 5 minutes of inactivity.
5 Perform one or more of the following on-target patch
management CLI commands:
•
pload
•
pins
•
poos
•
pout
•
pstat
--End--
Target patcher CLI commands
The on-target patch management CLI provides an interface command
set similar to the CS 1000 patcher.
Table 4 "Target-side patching CLI
commands" (page 108) lists target-side patching CLI commands.
Table 4
Target-side patching CLI commands
Command Description
pload Load a patch from a disk file and update the
on-switch database with the specific patch
information.
pins Put a patch into service; the patch will be placed
into service for all processes to which it applies.
poos Remove a patch from service. The patch is
removed from service from all processes in
which it was in service.
pout Unload a patch that was loaded with the pload
command.
Nortel Communication Server 1000
Linux Platform Base and Applications Installation and Commissioning
NN43001-315 02.09
29 October 2008
Copyright © 2007–2008 Nortel Networks
.