Ibm x306m bios settings, Changing the bios settings on an ibm x306m server – Nortel Networks NN43001-315 User Manual
Page 134
134
COTS Servers
IBM x306m BIOS settings
The BIOS settings on the IBM x306m server shipped through Nortel are
correct. These settings can be viewed at
Table 8
IBM x306m default BIOS settings
BIOS value
Default setting
Devices and I/O port - serial port A
Enabled
Devices and I/O port - baud rate
9600 baud
Devices and I/O port - console type
PC ANSI
Devices and I/O port - flow control
Off
Devices and I/O port - continue C.R. after POST
On
Devices and I/O port - type of connector
9-pin serial female
Start options - legacy USB support
Disabled
The IBM x306m server default BIOS settings can be changed by a BIOS
reset or other maintenance activity. To return the BIOS settings to the
appropriate values, see
“Changing the BIOS settings on an IBM x306m
for instructions.
For information about how to enable or disable the BIOS password on the
IBM x306m server see
“Setting the IBM x306m server BIOS password”
.
Changing the BIOS settings on an IBM x306m server
Step
Action
1
Press the Power switch to boot the server.
The server boots and the Press F1 for Configuration/Setup
message appears on the maintenance terminal.
Note: If the server is already up and running, power the server
off and on or press the reset button to reboot and receive the
Press F1 for Configuration/Setup message.
2
Press F1 to invoke the IBM x306m server Configuration/Setup
Utility.
The Configuration/Setup Utility menu screen appears.
Nortel Communication Server 1000
Linux Platform Base and Applications Installation and Commissioning
NN43001-315
02.09
29 October 2008
Copyright © 2007–2008 Nortel Networks
.