NAD T 765 - Manual (Page 30)

LISTENING TO RADIO
The T 765’s internal AM/FM tuner offers very high quality sound from radio broadcasts. The reception
and sound quality will always be dependent to a degree however on the type of antenna(s) used as
well as proximity to the broadcast origin, geography and weather conditions.
ABOUT ANTENNAS
The supplied ribbon-wire FM antenna can be connected to the rear-panel FM-antenna input using the
included ‘balun’ adapter and should be fully extended to form a “T”. This folded-dipole antenna will usually
work best when oriented vertically, with the arms of its “T” fully outstretched and arranged perpendicular
to the origin of the desired broadcast. There are no ‘rules’ however, and experimenting freely with antenna
placement and orientation may yield the clearest sound and lowest background noise.
In areas of poor FM reception, an exterior FM antenna can improve performance dramatically. If radio listening
is important to you, consider consulting an antenna installation professional to optimize your system.
The supplied AM ‘loop’ antenna will usually provide adequate reception. However, an exterior AM
antenna can be used to improve reception. Consult an antenna professional for more information.
ASSEMBLING THE LOOP ANTENNA
1 Rotate the outer frame of the antenna.
2 Insert the bottom edge of the outer frame into the groove on the stand.
3 Extend the antenna cord.
SELECTING THE RADIO
Press the ‘AM/FM/DB’ button on the T 765 front panel or the numeric ‘+10’ of the HTR 3 while at AMP or
TUNER device selector page to select the T 765’s radio mode. Each subsequent press of either key will
toggle the unit among AM, FM and XM radio.
TUNING STATIONS
1 Press TUNE
/ on the front panel momentarily to step up or down between AM or FM frequencies.
2 Press and hold TUNE or TUNE for more than 2 seconds to search up or down - the T 765’s
tuner will stop at the next sufficiently strong signal it encounters. Pressing the TUNE /
during the search process will stop the search.
3 After first pressing ‘TUNER’ (yellow lettering) at the Device Selector page of HTR 3 to set the remote
to control Tuner functions, press TUNE or TUNE (yellow lettering) on the HTR 3 – toggle in
to perform slow manual search, press and hold to automatically search.
SETTING RADIO PRESETS
The T 765 can store a mix of your 40 favorite AM, FM and XM radio stations for immediate recall.
1 To store a radio preset, first tune the desired frequency (see above), then press the front panel
‘MEMORY’ key.
2 Press the PRESET / keys to select a ‘Preset Free’ number to be assigned.
3 Then, press the ‘MEMORY’ key once again to save the station to the particular Preset number and
displaying ‘P_ _’ (the two blank spaces will correspond to the preset number that could be from ’01’
to the maximum of ’40’) on the VFD.
4 Press PRESET / on the front panel to step up or down between presets. Press and hold
PRESET / to “scroll” continuously up or down. The HTR 3 remote’s ‘PRESET’ keys work similarly.
The Radio Presets must be stored from the front panel. This setup function is not accessible from the
HTR 3 remote control.
NOTE
The T 765’s Radio Presets are distinct from its ‘global’ Presets that can be used to manage listening
and setup modes and levels. See ‘A/V Presets’ above.
OPERATION
USING THE T 765 – AM/FM/DB/iPod
0
EN
G
LIS
H
FR
A
N
Ç
A
IS
ES
PA
Ñ
O
L
IT
A
LIA
N
O
D
EU
TS
CH
N
ED
ER
LA
N
D
S
SV
EN
SK
A
РУ
СС
К
И
Й