Identification of controls – NAD T 765 User Manual

Page 9

Advertising
background image

11 SOURCE : Press these buttons to toggle through the input

selections – Source 1, Source 2, Source 3, Source 4, iPod, Source 7, Front
Input, Media Player and Tuner. More Sources could be directly recalled
through these buttons upon enabling them at the Setup Menu (See the
section ‘Source Setup’ at Setup Menu discussion).

12 LISTENING MODE : Use to step through the T 765’s Listening mode as

discussed in the section ‘About the T 765’s Listening Modes.’ Depending
on the format of the currently selected input (digital or analog, stereo or
multichannel), various listening modes are available.

13 TONE CONTROLS : Press to adjust TREBLE control using the VOLUME

knob over a + 10dB range. Press again to adjust BASS control and a third
time for DIALOG control. See also section about ‘Tone Controls’ under
‘Setup Menu’ discussions.

14 TONE DEFEAT : Tone Controls are enabled or disabled by pressing

this button. Tone controls are bypassed at ‘Tone Defeat’ while at ‘Tone
Active,’ the tone controls are enabled again. See also section about ‘Tone
Controls’ under ‘Setup Menu’ discussions.

15 FRONT INPUT/MP : Use this button to directly select Front Input and

Media Player. Toggle button to switch between Front Input and Media
Player input.

16 PHONES : Accepts stereo headphone using a standard 1/4-inch stereo

phone plug (use a suitable adapter for headphones equipped with a
smaller plug). For headphone listening, the Front speakers must be set
to “Large” at the ‘Speaker Configuration’ of the Speaker Setup item at
the Setup Menu, otherwise headphone bass response will be restricted.
Plugging in headphones will automatically switch the T 765 to Stereo,
Stereo Downmix or Analog Bypass modes.

17 FRONT INPUT jacks : Use these convenience jacks for occasional

sources such as a camcorder, tape player, video game console, any
analog audio or optical digital audio and composite or S-Video video
sources. If your source has a single audio out jack only or is marked
‘mono output’ , plug this into the T 765’s Front ‘R (Mono)’ input. On the
other hand, if your source has two output jacks indicative of stereo
output, insert both jacks into the T 765’s corresponding Front ‘L’ and ‘R
(Mono)’ input to achieve stereo output as well.

18 MP/MIC input : Connect your MP3’s standard stereo phone jack to

this input. This is the same input where Audyssey microphone jack is
connected (See also discussion about ‘Audyssey Setup).

IDENTIFICATION OF CONTROLS

FRONT PANEL



EN

G

LI

SH

FR

ANÇ

AIS

ESP

AÑOL

IT

ALIANO

DEUT

SCH

NEDERL

ANDS

SVENSK

A

РУ

ССКИЙ

Advertising