NAD T 765 - Manual (Page 6)

INTRODUCTION
GETTING STARTED
WHAT’S IN THE BOX
Packed with your T 765 A/V Receiver you will find
• An AM loop antenna
• A FM ribbon-wire antenna with balun
• A removable AC cable (if you wish, any IEC-standard AC cable of suitable wattage may be substituted).
• The HTR 3 remote control with 4 (four) AAA batteries.
• The ZR 4 zone remote control with 3V CR2025 battery.
• This owner’s manual.
SAVE THE PACKAGING
Please save the box and all of the packaging in which your T 765 arrived. Should you move or
otherwise need to transport your T 765, this is by far the safest container in which to do so. We’ve seen
too many otherwise perfect components damaged in transit for lack of a proper shipping carton, so
please: Save that box!
INITIAL SETUP
Before you make the first connection to your T 765, you should have the arrangement of your
listening room/home theater components and furniture mapped out, at least initially. Unfortunately, a
discussion of the vital questions of loudspeaker placement and listening/viewing positions is beyond
our scope here.
Suffice it to say that these two questions will influence your system’s ultimate performance every bit
as powerfully as your selection of electronics and speakers. Your NAD audio specialist dealer will be
happy to advise you and to recommend reference materials.
CHOOSING A LOCATION
Choose a location that is well ventilated (with at least several inches to both sides and behind), and
that will provide a clear line of sight, within 25 feet/8 meters, between the T 765’s front panel and your
primary listening/viewing position—this will ensure reliable infrared remote control communications.
The T 765 generates a modest amount of heat, but nothing that should trouble adjacent components.
It is perfectly possible to stack the T 765 on top of other components, but the reverse usually should
be avoided. Nonetheless, it is generally preferable that the T 765 stand alone. It is especially important
that sufficient ventilation be provided. If you are contemplating on locating the T 765 within a cabinet
or other furniture, consult your NAD audio/video specialist for advice on providing adequate airflow.
QUICK START
Packed with your T 765 is a Quick Start Guide that will guide you through typical setup configurations
in combination with your ancillary devices. The Quick Start Guide also features the contents of your
T 765 package as well as start up procedures.
The T 765 is defaulted to the following settings:
Source Audio Input Video Input Video Output
Source 1
Optical 1/
Audio 1 IN
Component Video 1 IN Component Video OUT
Source 2
Optical 2 IN/
Audio 2 IN/
HDMI 2 IN HDMI Monitor OUT
Source 3
Coaxial 3 IN /
Audio 3 IN
S Video 3 IN S-Video Monitor OUT
Source 4 Audio 4 IN Video 4 IN Video Monitor OUT
iPod Audio 5 IN S-Video 5 IN S-Video Monitor OUT
Source 7 7.1 Input Component Video 3 IN Component Video OUT
Front Input
Audio Front Input/
Optical Front Input
S-Video Front IN S-Video Monitor OUT
Media Player Audio MP input
Tuner
To modify the above default settings and for a better understanding of source setting and
combinations, please refer to the section on ‘Source Setup’ of the Setup Menu discussion.
NOTES
• Digital input will always take precedence over analog audio input even if both are present.
• The T 765 is optimized for Component Video Output. Composite video and S-video sources may be
viewed in their native format or via Component Video OUT.
6
EN
G
LIS
H
FR
A
N
Ç
A
IS
ES
PA
Ñ
O
L
IT
A
LIA
N
O
D
EU
TS
CH
N
ED
ER
LA
N
D
S
SV
EN
SK
A
РУ
СС
К
И
Й