NETGEAR SPH200D - Manual (Page 66)

Cordless Internet Phone with Skype Model SPH200D User Manual
7-4 Settings and Maintenance
v1.0, November 2006
• Reset All. Reset all the settings including the network settings.
• Keep Network. Reset all the settings except the network settings.
3. Enter the system PIN. Press Clear to make corrections.
4. Press Yes to confirm.
5. The settings will reset. Y our handset’s power switches off. It will switch back on in a few
seconds after updating all the settings.
Registering Your Handset
Registration lets your base unit and handsets communicate. Your handset must be linked to the
base in order to make calls and to use many of features on the phone.
Your handset is already registered unless you have bought an extra handset individually, or you
have de-registered a handset. For additional handsets, see
“Registering Your Handset(s) with an
Additional Base” on page 7-5 . If the handset is not registered, it displays “Unregistered.”
Follow the steps below to register your handset.
1. Press Menu>Settings>Handset>Register.
2. Enter the system PIN (Default: 0000). Press Clear to make corrections.
3. Press Enter to confirm. Your handset starts searching for the base.
4. Press on the base unit until the LED starts flashing.
5. The handset registers to the particular base unit, and shows the signal icon .
Note: Your base unit can register up to four handsets. After registering four handsets,
your base unit registration memory is full. If you try to register an additional
handset, the registration process will not complete.