NETGEAR SPH200D - Manual (Page 72)

Cordless Internet Phone with Skype Model SPH200D User Manual
7-10 Settings and Maintenance
v1.0, November 2006
Accessing the Web Page
To access the Web page, follow these steps:
1. Open a Web browser.
2. Enter your phone’s IP address at the address bar. An authentication window pops up.
3. Enter the user name and password. The default user name is admin and the default password
is password.
After verifying your user name and password, you will see the configuration home page.
• Home page. The home page shows your current system and network settings.
• Network page. The network page shows your current Internet connection type and Ethernet
speed. You can make changes to these settings on this page.
• Skype page. The Skype page shows your current Skype status. You can create a new Skype
account or sign in to Skype from this page.
• System page. You can upgrade your phone’s operating system from this page. You will first
need to download the latest software from the NETGEAR Web page, at
www.netgear.com .
• Administration page. You can change the Web page access password on this page. You can
also reset your phone to factory default feature and network settings.
Troubleshooting
Tip: To find your phone’s IP address, see “Viewing Network Settings” on page 7-8 .
Table 7-1. Troubleshooting Tips
Problem Tip
No dial tone on landline. • Check the phone and power connections.
• The handset may be out of range. Move closer.
• The battery capacity may be low. Charge battery.
Signal icon flashing. • The handset may be out of range. Move closer.
• If the handset displays Unregistered, it is not registered. Register the
handset. See “Registering Your Handset” on page 7-4 .