National Instruments 370620B-01 - Manual (Page 2)

PCI/PXI Gigabit Ethernet Adapters Installation Guide 2 ni.com
3. Remove the cover to give yourself access to the expansion slots.
4. Choose an empty PCI slot and remove the slot cover by unscrewing the
screw that secures it.
5. Insert the adapter into the PCI slot and push until it is firmly seated.
Reinstall the screw you removed in step 4.
6. Replace the cover and plug in the power cord.
Connect the Network Cable
Complete the following steps to connect the network cable:
1. Connect a Twisted Pair Ethernet (TPE) network cable to the adapter as
shown in Figure 1.
Figure 1. Connecting the Network Cable
• For 1000BaseT (gigabit over copper), use Category 5 (must be
4-pair wiring). Be sure to use Category 5 cable that complies with
the TIA-568 wiring specification. For more information on this
specification, refer to the Telecommunications Industry
Association Web site,
www.tiaonline.org .
• For 100BaseTX, use Category 5 wiring or better.
Caution If using less than 4-pair cabling, you must manually configure the speed and
duplex setting of the adapter and the link partner. In addition, with 2- and 3-pair cabling,
the adapter can achieve speeds of up to only 100 MB/s.
• For 10BaseT, use Category 3 wiring or better.
• To use this adapter in a residential environment (at any speed), use
Category 5 wiring. If the cable runs between rooms or through
walls and/or ceilings, it should be plenum rated for fire safety.