NeoDigits.com HVD2085 - Manual (Page 9)

Do not touch the signal (reflective) surfaces. Hold discs by the edges, or by one
edge and the center hole.
Do not affix labels or adhesive tapes to the disc surface – this will unbalance the
disc.
Do not scratch or damage the label – this will make the disc unreadable.
Discs run at high speeds inside the player. Do not use damaged (scratched or
warped) discs.
Dirty discs can cause player malfunctions. Always keep discs clean by gently
wiping the surface with a soft clean cloth (moving from the inner to the outer
perimeter)
If I disc is dirty, wet a soft cloth in water, wring out the cloth thoroughly, wipe the
dirt away gently, and then remove any water drops from the disc with a soft dry
cloth.
Do not use record-cleaning sprays or anesthetic agents on discs. Never clean
discs using benzene, thinner or other volatile solvents which may cause damage
to disc surfaces.
To avoid warping discs, store discs in their original cases. Do not leave discs
under high temperature and humidity.
Proper use and handling of discs:
Disc running display
Repeat all
Repeat track
Chapter/Track number
Hours 1.
2.
3.
4.
5. Minutes
Seconds
Disc type(MP3)
PBC
DVD playback angle 6.
7.
8.
9.
10. Dolby Digital
SVCD
Pause mode
DTS logo
Play mode
Disc type(DVD) 11.
12.
13.
14.
15.
16.