NetComm N300 - Manual (Page 19)

YML9WMAXXN ADSL2+ Wireless N300 Modem Router with VoIP User Guide
www.netcomm.com.au 19
NetComm Gateway TM Series - ADSL2+ Wireless N300 Modem Router with VoIP
6: Upon completion click Next. The following screen appears.
Consult the following paragraphs for more details about these settings.
The Device Setup screen allows the user to configure the LAN interface IP address and DHCP server. If the user would like this router to
assign dynamic IP addresses, DNS server and default gateway to other LAN devices, select the radio box Enable DHCP server to enter
the starting IP address and end IP address and DHCP lease time. This configures the router to automatically assign IP addresses, default
gateway address and DNS server addresses to each of your PCs.
Select Enable DHCP Server Relay (if required), and enter the DHCP Server IP Address. This allows the router to relay the DHCP packets
from the remote DHCP server. The remote DHCP server will provide the IP address.
NOTE: If NAT is enabled, Enable DHCP Server Relay won’t display.
To configure a secondary IP address for the LAN port, tick the checkbox shown.
7: Click Next to continue. To enable the wireless function, tick the checkbox (as shown), input a new SSID (if desired) and click Next.