Netcomm gateway – NetComm N300 User Manual
Page 29
YML9WMAXXN
ADSL2+ Wireless N300 Modem Router with VoIP User Guide
www.netcomm.com.au
29
NetComm Gateway
TM
Series - ADSL2+ Wireless N300 Modem Router with VoIP
CALL COMMAND LIST
Caller ID
The Call Manager delivers Caller ID when placing calls. The caller ID is transmitted to the analog line for CLASS recognition.
Call Hold
To put a call on hold, press flash then hang up (optional). To return to the original call, press flash or pick up the phone. The phone will
issue a short ring burst every 30 seconds or so while on-hook to remind you that a call is on hold.
Call Transfer
•
To transfer a call, press flash then dial the new number.
•
To transfer immediately, hang up (blind transfer).
•
To transfer with consultation, wait for the party to answer, consult, and hang up.
•
To abort the transfer (if the third party does not answer); press flash to return to the original call.
Conference Calling
To turn a two-party call into a three-party conference call, press flash and dial the third party. Wait for the party to answer, then press flash.
To drop the third party and return to a two-party call, press flash again. To drop yourself out of the conference, hang up. The call will be
transferred (so that the other two parties remain connected to each other).
NOTE:
In conference mode, the conference initiator performs the audio bridge/mixing function – there are only two voice streams established.
Call Waiting
If call waiting is enabled on a line, and you hear the call waiting tone during a call, press flash to answer the second call. The first call is
automatically placed on hold. To switch between calls, press flash again.
•
To disable the call waiting feature, dial *60.
•
To enable the call waiting feature, dial *61.
NOTE:
Call forward feature settings (Busy or All) take priority over the call-waiting feature. The call-waiting feature is ignored on new incoming calls if there is already a call on
hold or in conference.
Call Forward Number
•
To set the call forward number, dial *74 then the number. (Note that this does not actually enable forwarding; to do so, select the
call forward action as described below.)
•
To disable all call forwarding features, dial *70
Call Forward No Answer
•
To enable call forward on no answer, dial *71. Incoming calls will be forwarded if unanswered for 18 seconds.
Call Forward Busy
•
To enable call forward if busy, dial *72. Incoming calls will forward immediately if the phone is off-hook.
Call Forward All
•
To enable call forward for all calls, dial *73.
•
To disable the “forward all calls” feature, dial *75. Settings for Call Forward Busy or
No Answer are not modified.
Call Return
•
To place a call to the last known incoming caller (unanswered or not), dial *69.
Redial
•
To redial the last outgoing number, dial *68.