Nikon LS-4500AF - Manual (Page 40)

20 Nikon Film Scanner LS-4500AF User's Manual
Remarks
• The maximum number of SCSI devices that can be connected to one
computer is eight. In the case of a host computer with a built-in SCSI
hard disk or built-in CD-ROM, note that SCSI ID numbers have been
pre-assigned for the host CPU and the SCSI devices.
• The SCSI cable must not be extended beyond a total length of 19 feet (6
meters), or else failure may result.
• If you use the type of terminator that is inserted between the SCSI cable
and SCSI interface connector, install a terminator independent of the
other SCSI connector of the LS-4500AF.
• Terminators must be attached to the devices located at both ends of the
SCSI chain.
If the host computer is a Macintosh, the Macintosh itself will provide
termination at one end of the chain.
If the host computer is an IBM PC/AT or compatible, equipped with a
SCSI board, the SCSI board itself will present termination at one end of
the chain.
Note that when a SCSI chain connection is made inside a computer, the
end of the SCSI device inside the computer will become the end
terminal.
• Before installing a SCSI board, be sure to read the user’s manual
provided with the board. The numbers for the I/O address, interrupt
level (INT) and DMA channel might be used for other interface boards
and peripheral devices. If so, change them as explained in the manual.
4. Connecting the LS-4500AF