Nikon LS-4500AF - Manual (Page 60)

40 Nikon Film Scanner LS-4500AF User's Manual
Step 6
Close the inner cover. Push the inner cover closed until it clicks, then close
the outer cover.
Step 7
Connect the power cord and run the application software after turning on
the power. If the application software has a command for lamp calibration,
execute it. If the application software does not have a calibration function,
and command entry is possible, enter “LCB” from the keyboard.
The LS-4500AF registers the initial value of the lamp in the system. When
the BUSY LED goes out, the operation is completed. The calibration
operation is only necessary when the lamp is replaced, not in daily use.
Calibration is performed when the power is turned on.
7. Replacing the Lamp