National Instruments PCI-4452 - Manual (Page 112)

Index
© National Instruments Corporation I-5 PCI-4451/4452 User Manual
I
I/O connectors, 4-1 to 4-8
developing cable connectors, 1-5
exceeding maximum ratings
(warning), 4-1
pin assignments (table)
analog I/O, 4-3
digital I/O, 4-6 to 4-7
pin connections
68-pin digital connector (figure), B-2
analog (figure), 4-2
digital (figure), 4-5
signal summary (table)
analog I/O, 4-4
digital I/O, 4-8
input coupling
analog input, 3-3
theory of operation, 6-2
input mode, 3-3
input polarity and range, 3-3 to 3-4
actual range and measurement precision
(table), 3-4
exceeding rated input voltages
(caution), 3-5
selection considerations, 3-4 to 3-5
installation
hardware, 2-1 to 2-2
software, 2-1
unpacking PCI-4451/4452, 1-2
J
jitter, with triggering, 3-7
L
LabVIEW and LabWindows/CVI application
software, 1-3
M
manual. See documentation.
Measure software, 1-4
mute feature, 6-13
N
noise, avoiding, 4-24 to 4-25, 6-9
Nyquist frequency, 6-3
O
onboard calibration reference specifications,
A-5
optional equipment, 1-4
output mode, 3-5
output polarity and range, 3-5 to 3-6
actual range and measurement precision
(table), 3-6
boot modes (note), 3-6
P
PCI-4451/4452. See also hardware overview.
custom cabling, 1-4 to 1-5
optional equipment, 1-4
overview, 1-1
requirements for getting started, 1-2
software programming choices, 1-3 to 1-4
ComponentWorks, 1-4
LabVIEW and LabWindows/CVI
application software, 1-3
Measure, 1-4
National Instruments application
software, 1-3 to 1-4
VirtualBench, 1-3
unpacking, 1-2
PFI0/TRIG1 (EXT_TRIG) signal
digital I/O pin assignments (table), 4-6
digital I/O signal summary (table), 4-8
timing connections, 4-16
User.book Page 5 Tuesday, April 14, 1998 10:20 AM