Figure 2-1. how to set up your imaq system – National Instruments PCI-1428 User Manual
Page 17
Chapter 2
Installation
© National Instruments Corporation
2-3
Figure 2-1. How to Set up Your IMAQ System
Measurement Studio
(LabWindows/CVI, Visual C++,
Borland C++)
LabVIEW
What
application software
are you using?
Configure your hardware using
Measurement & Automation Explorer and
online help.
Read the
Getting Started with Your IMAQ System
document and the NI-IMAQ release notes to install
your NI-IMAQ software, IMAQ hardware,
and documentation.
Measurement
Studio
(Visual Basic)
Read
Getting Results with
ComponentWorks IMAQ Vision
for information on using
ComponentWorks in your
application environment.
Use the ComponentWorks
IMAQ Vision documentation
when you need specific
information about individual
NI-IMAQ functions.
Read Chapter 1,
Introduction
to NI-IMAQ, in the
NI-IMAQ User Manual.
Read the sections in
chapters 2 and 3 in the
NI-IMAQ
User Manual that apply to the
function groups you
will use in your application.
Look at the self-documented
example source code on your
distribution CD for your
application language
and environment.
Use the
NI-IMAQ Function
Reference Manual when you
need specific information about
individual NI-IMAQ functions.
If you are using IMAQ Vision for
LabWindows/CVI, read the
documentation for IMAQ Vision
for LabWindows/CVI.
Read:
• The section in chapter 4 in the
NI-IMAQ User Manual for
information on using LabVIEW
with your IMAQ hardware.
• NI-IMAQ VI online help
• Your IMAQ Vision for
LabVIEW documentation
if you are using IMAQ
Vision for LabVIEW