Net Optics 96547iTP - Manual (Page 14)

iTap GigaBit Dual Port Aggregator
10
For security reasons, some parameters can only be set with the CLI.
Use these commands to:
Set CLI username and password
Enable or disable the remote interfaces and display
Turn character echo to the terminal emulation software on or off
You will fi nd a complete list of CLI commands in Appendix B.
If you wish to disable the Management Port and remote interfaces, you can do so
from the CLI using the Display command.
To access the iTap CLI:
1. Make sure power to the iTap is off.
2. Connect a PC with terminal emulation software, such as HyperTerminal, to the
iTap using the RS232 DB-9 cable supplied with the iTap.
3. Launch terminal emulation software and set the communication parameters to:
19200 baud
8 data bits
No parity
1 stop bit
No fl ow control
3. Connect power to the iTap. The CLI banner and login prompt appears.
Figure 6: Login and Password Prompts
4. Type netoptics and press Enter.
5. At the password prompt, type netoptics and press Enter. The NetOptics:
prompt appears.
•
•
•