Net Optics 96547iTP - Manual (Page 22)

iTap GigaBit Dual Port Aggregator
18
Figure 14: Connecting Power
Checking the Installation
After you have connected the iTap to the network, monitoring device and power,
verify that the iTap is functioning correctly.
Check that at least one power LED is illuminated.
Check the link status LEDs located on the front panel to verify that traffi c is
passing through the iTap.
Check the display for utilization and peak information.
Verify that the monitoring device is receiving traffi c from the iTap.
Verify that the Management Port is functional by typing the iTap's IP address in
your Web browser. Net Optics' Web Manager should appear. If it does not, check
the Management Port cables and connections and verify that the Display option
in the CLI is set to ON. •
•
•
•
•
Management
Port
RS232