Network Technologies ST-xU - Manual (Page 15)

NTI NODEMUX SERIES UNIVERSAL KVM SWITCH
11
Additional Modes Available With Security
Note: The three modes that follow are only available if the administrator is logged in.
Administration Mode
Administration Mode allows the administrator to use the following functions:
Function:
Keystroke:
Configure switch- for application
and RS232 communication
(not found in legacy NODEMUX)
Change the administrator’s
password
Enter User Name List Mode
Disable security
Figure 10- Administration Mode menu
Selects the idle time in seconds
Exit Administration Mode and
return to previous mode
Switch Configuration
Switch Configuration enables the administrator to configure the NODEMUX to be used as a stand alone switch or as one of the
switches in a cascaded system.
Note: Cascading is no longer supported in this switch. Be careful not to change this field to anything except “STAND
ALONE SWITCH”.
Switch Configuration is also used to setup the communication settings for RS232 communication with a remotely connected
terminal through the RS232 port. For the Switch Configuration Mode menu, press <W> from the Administration Mode menu
(above).
Figure 11- Switch Configuration Mode screen
Esc
T - -
(xxx from 000 to 255. ie. t002
would set the time-out period
for 2 seconds. 000 will disable it)
- (0-2)
x (0-9)
x (0-9)
x
S
C
U
W
Be careful with
this field. If
changed to
“SLAVE”, OSD
will not work after
power cycling.
In the event the setting is changed
from "stand alone" to "slave", when
the switch is power cycled the OSD
menu will no longer work. To restore
the setting back to "stand alone",
factory default settings must be
restored via a terminal connected to
the RS232 control port. See the
RS232 Command "CF" on page 24 to
restore default settings.