Network Technologies ST-xU - Manual (Page 9)

NTI NODEMUX SERIES UNIVERSAL KVM SWITCH
5
INSTALLATION
1. Turn OFF power to all CPUs that will be connected to the NODEMUX before connecting or disconnecting any cables to or
from them.
WARNING ! DAMAGE MAY OCCUR TO THE CPU IF POWER IS NOT DISCONNECTED BEFORE CONNECTING OR
DISCONNECTING CABLES .
2. Connect the monitor to the port labeled MONITOR on the rear of the NODEMUX.
Figure 3- Connect the monitor
3. Connect the input devices (keyboard/mouse) to the port labeled DEVICES on the rear of the NODEMUX following one of the
methods detailed below:
•
PS/2 keyboard and mouse- attach the 8-pin male end of a VKTINT-1 to the NODEMUX at the DEVICES port. The
keyboard will plug into the 6-pin purple female connector with the keyboard symbol on it (see Fig. 4a), and the mouse will
plug into the 6-pin green female connector with the mouse symbol on it (see Fig. 4b).
Figure 4- Connect a PS/2 keyboard and mouse
Fig. 4b Fig. 4a
Keyboard Symbol Mouse Symbol
!
DEVICES
8 Pin miniDIN Female
Connector PS/2 Keyboard
VKTINT-1
PS/2
Mouse
6 Pin miniDIN Male
Connector
(GREEN)
(PURPLE)
8 Pin miniDIN Male
Connector
8 4 7 3 6 2 5 1 VIDEO VIDEO
NETWORK TECHNOLOGIES INC Tel:330-562-7070 1275 Danner Dr, Aurora, OH 44202 ww w.nti1.com
Rear View of NODEMUX
CPU 4 CPU 3 CPU 2 CPU 1
CPU 8 CPU 7 CPU 6 CPU 5 DEVICES
MONITOR
R
S
2
3
2
VGA
Multi-Scan
Monitor
MONITOR
15HD Male
Video Connector
15HD Female
Video Connector
8 4 7 3 6 2 5 1 VIDEO VIDEO
NETWORK TECHNOLOGIES INC Tel:330-562-7070 1275 Danner Dr, Aurora, OH 44202 www.nti1.com
Rear View of NODEMUX
CPU 4 CPU 3 CPU 2 CPU 1
CPU 8 CPU 7 CPU 6 CPU 5 DEVICES
MONITOR
R
S
2
3
2