Navini Networks Ripwave MX - Manual (Page 11)

Navini Networks, Inc. Ripwave MX Modem User Guide
Installing the
Modem
(See, also, Addendum 1)
The following instructions explain how to install your Modem.
Please read all instructions before installing the Modem. Also, turn
off the computer and the Modem before installing the Modem.
Note: The Modem should be positioned to minimize
interference with other equipment when transmitting. Also,
Australian requirements state the Modem should be placed 30 cm
or more from any person or user. If the antenna is closer than 20
cm from the user, Australian safety conditions are violated.
Step Action
Illustration
1. Connect the Ethernet
cable to the Ethernet
port on the computer.
2. Connect the other end of
the Ethernet cable to the
Modem.
3. Connect the AC power
adapter to the Modem.
Plug the other end of the
power adapter into a
110/220 VAC 60/50 Hz
outlet.
CAUTION! Use only
the AC power adapter
supplied with the
Modem. Using any other
adapter can damage the
Modem.
Ethernet cable
connection Ethernet cable
connection
Power adapter
connection Power adapter
connection
11
060825_pv1.6_Ripwave-MX Modem User Guide_40-00382-00Rc(4.5)