Navini Networks Ripwave MX - Manual (Page 7)

Navini Networks, Inc. Ripwave MX Modem User Guide
Regulatory Information
FCC Notice
CAUTION: This device is a Radio Frequency transmitter. It is required to comply with FCC RF exposure
requirements for transmitting devices. For all LMX Modems except for the 2.6 LMX with window mount,
a minimum separation distance of 8 inches (20 cm) or more must be maintained between the antenna and
all persons during device operations to ensure compliance with the FCC’s rules for Radio Frequency
Exposure. For the 2.6 LMX Modem with a window mount, a minimum of 8.3 inches (21 cm) or more
must be maintained between the window mount antenna and all persons during device operations. If this
minimum distance cannot be maintained, exposure to RF levels that exceed the FCC’s limits may result.
FCC Compliance and Advisory Statement
This equipment has been tested and found to comply with the limits for a class B digital device, Pursuant
to Part 15 of the FCC rules. The operation is subject to the following two conditions:
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
If this equipment causes interference to radio or television reception, which can be determined by turning
the equipment off and on, the user should try to correct the interference by one or more of the following
measures:
1)
Reorient or relocate the receiving antenna,
2) Increase the separation between the equipment and the receiver,
3) Connect the equipment to an outlet on a circuit that is different from the one to which the receiver
is connected,
4) Consult the dealer or an experienced radio/TV technician for additional suggestions.
This product has been tested and found to be safe in accordance with the Australian Standard for Human
Exposure to Radiation where the user or other parties are 20 cm or more from the aerial.
INFORMATION TO USER
This device has been authorized as a radio frequency transmitter under the appropriate rules of the Federal
Communications Commission. Any changes or modifications not expressly approved by Navini Networks
could void the user’s authority to operate the equipment.
INFORMATION REGARDING ANTENNAS
This device has three embedded antennas: one upright antenna with approximately 2 dBi gain and two
patch antennas, one on each side of the device. Each patch antenna has approximately 6 dBi gain.
This product has been tested and met all the applicable requirement of the R&TTE directive (99/5/EC).
For 2.4 LMX, the intended EU countries to export are: Italy, Spain, Germany and France.
7
060825_pv1.6_Ripwave-MX Modem User Guide_40-00382-00Rc(4.5)