Network Technologies CAT5 User Manual
Page 13
8
(Rear View)
CAT5 Cable
to User Station
Cable to CPU
Terminating
Plug (Supplied)
The HA-RS Host Adapter includes with a base for mounting to any desired surface. To Host Adapter snaps-in securely, and is
quickly released from the base by applying pressure to the two release tabs, as shown in the image below.
Figure 7- HA-RS mounting base
For instruction on configuration of the HA-RS to make connection to the serial device, see page 41.
Connecting the CAT5 cable to the Host Adapter
Connect CAT5 cable to the “OUT” port on the Host Adapter. (See Figure 8.) When properly inserted the cable end should snap
into place. Also be sure to insert the Terminating Plug (HA-PLGTRM) into the "IN" port on the Host Adapter if this is the only Host
Adapter in the system. Otherwise, see "Daisy-Chained Host Adapters" on page 9 to add more Host Adapters to the system.
WARNING: Never connect the PRIMUX Host Adapter to an Ethernet card,
Ethernet router, hub or switch or other Ethernet RJ45 connector of an Ethernet
device. Damage to devices connected to the Ethernet may result.
NOTE: The installer must ensure that all CAT5 cable between the Host
Adapter
and User Station is of the straight-through type and not crossed.
Figure 8- Connect CAT5 cable to Host Adapter
!
To release adapter apply
pressure as shown