Network Technologies CAT5 - Manual (Page 17)

12
Power Up for the first time
Note: The user devices, monitor, and CAT5 cable should already be connected before powering up the User Station .
1.
Connect the AC adapter power connector to the 5VDC port on the User Station (see Figure 13). Plug the AC adapter into a
power outlet and press the power switch to turn the User Station ON. The yellow LED on the RJ45 connector of the User
Station should illuminate, indicating that a proper power connection has been made to it.
2.
Re-connect the power cord to the CPU.
FYI: The Host Adapter is powered by the CPU.
3. Power up the monitor.
Figure 13- Connect the AC adapter to the User Station
4.
With the User Station and Host Adapter connected via CAT5 cable, refer to "Using the PRIMUX " on page 13.
FYI: The green LED on each RJ45 connector will illuminate anytime data traffic is passing between the Host Adapter and
User Station, indicating proper CAT5 cable connection and communication. (See Figure 13)
Barrel
(Inside
barrel) (Outside
barrel)
Power Connector
2.1 mm x 5.5 mm Female
5VDC @ 2.0A OUTPUT
Green-Communication
LED Yellow-Power
LED
5 VDC
AC
ADAPTER
Rear View of PRIMUX-UZR
C at5 M o n it o r
S UN
D evices
P S/2
D evices
Mo u se K ybd R S23 2
U SB
D evic es
5V DC
2A
NE TW O RK
TE CH N O L O G IE S
IN CO R P O R A TE D Te l:3 3 0 -5 62 - 70 7 0
Fa x :3 3 0- 5 62 -1 9 9 9 1 27 5 Da nn er D r
Au rora , O H 4 42 0 2
w w w .nti1 .c om
N TI
R
+
Rear View of PRIMUX-UZR User Station