Network Technologies CAT5 - Manual (Page 16)

11
Figure 11- Connect extended USB components to the User Station
Connecting the CAT5 cable to the User Station
Make sure the CAT5 cable has been installed in accordance with the “Preparation for Installation” instructions on page 4.
Connect the CAT5 cable to the RJ45 connector labeled “Cat 5” on the User Station. (See Figure 12.) When properly inserted the
CAT5 cable end should snap into place.
WARNING: Never connect the PRIMUX-UZR User Station to an Ethernet card, Ethernet router, hub or switch
or other RJ45 connector of an Ethernet device. Damage to devices connected to the Ethernet may
result.
Figure 12- Connect CAT5 cable to User Station
NOTE: If an RJ45 wall outlet is being used, connect the other end of the extension cable to the RJ45 wall outlet.
!
C at5 Mo n it o r
S UN
D evices
P S/ 2
D evices
M o u s e K ybd R S232
U SB
D evices
5V DC
2A
NE TW O RK
TE CH NO LO G IE S
IN CO RP O RA TE D Tel:3 3 0 -5 62 - 70 7 0
Fax :3 3 0- 562 -1 9 9 9 1 27 5 Da nn er D r
Au rora , O H 4 42 0 2
w w w .nti1 .c om
N TI
R
+
PRIMUX-UZR User Station
USB Type A male
VGA
Multi-Scan
Monitor
15HD male
video connector
15HD female
video connector
USB
Mouse
USB Keyboard
USB Type A female
device ports
CAT5 cable
to first Host Adapter
in the daisy- chain
RJ45 male
CAT5 connector
C a t5 Mo n it o r
S UN
D evice s
P S/2
D evice s
Mo u s e K ybd R S2 32
U SB
D evice s
5 V DC
2A
NE TW O RK
T E CH NO L O G IE S
IN CO RP O RA T E D Te l:3 3 0 -5 62 - 70 7 0
Fa x :3 3 0- 5 62 -1 9 9 9 1 27 5 Da nn er D r
Au rora , O H 4 42 0 2
w w w .nti1 .c om
N TI
R
+
Rear View of PRIMUX-UZR User Station