N-Tron 102PC-SE - Manual (Page 21)

(Revised 2010-11-15) 21
Web Management Tree of Menus
General Configuration
Authentication: Enables/Disables Authentication (Login Prompt) for command line configuration/management via Serial and Ethernet
Default: enable
BootMessage: Enables/Disables the display of boot-messages during module boot-up
Default: enable
Autodialout: Enables/Disables Telnet Auto-Dialout authentication
Default: enable
Watch Dog: Enables/Disables the watchdog timer (6.5 seconds by default)
Default: enable
User Configuration
Provides to add/delete/modify username and password to the group
Notes:
o
Default Groups: admin, users
o
Default Users: admin, ipmodule
o
Only Admin can configure the SocketEthernet IP
Port Configuration
Baud Rate :Sets the serial Baud Rate
Default: 115200
Buffer Size: Sets data buffer size to be sent from serial-to-ethernet.
Default: 0
Buffer Time: Sets the buffer time (t deci-secs) to wait before sending from serial-to-ethernet. If t=0, buffer-size=0 no delay. If t=0, buffer-size!=0 buffered
till the buffer-size. If t!=0, buffer-size=0, no delay. If t!=0, buffer-size!=0 buffered till the buffer-size or Wait till t deci-sec whichever occurs first.
Default: 0 deci-seconds
Flow Control: Sets the Flow Control of the serial port
Default value: rts-cts
Parity: Sets the serial Parity
Default value: none
Data Bits: Sets the serial Data bits
Default value: 8
Stop Bits: Sets the serial Stop bits
Default value: 1
Escaes.multiTech.socketProduct.seipInfo.seipIPSetup.seipIPServiceSetup.seipe Monitor: Enables/Disables „„monitor‟‟ flag to scan escape sequence
and switch to command mode during Manual dialin (telnet) session
Default: enable
Escape String: Sets the escape string to be scanned during Manual Dialin session to switch to command mode
Default: +++inet
Connect Type: Sets the connect type of the serial port to Direct/Modem
Default: Direct
Connect State: Sets the connect state of the serial port to dialing/answering
Default: Dialing
Trig Mode: Sets the trigger mode on the serial port. This mode controls starting/stopping of the Serial Configuration session and Auto-Dialin Session
Modes Description
o
char
Initiate a session (Configuration/Telnet/Udp), only on a reception of a character on the serial port s0
o
dtr
Initiate a session (Configuration/Telnet/Udp), only on seeing a DTR signal on the serial port s0
o
dtr-char
Initiate a session (Configuration/Telnet/Udp), either on reception of a character (OR) seeing the DTR signal on the serial port s0
o
none
Initiate a session (Configuration/Telnet/Udp), on module boot-up
Default: dtr-char
Login String: Sets the login string. When the trig mode is set to char/dtr-char and DTR is down, the session is initiated only if the configured login string is
entered
Default: NULL
Echo Command: Enables/Disables the command echoing on the serial port
Default: enable
Telnet messages: Enables/Disables the Telnet Client (Manual and Auto-Dialin) connect messages on the serial port
Default: disable
(continued…)