N-Tron 102PC-SE - Manual (Page 22)

(Revised 2010-11-15) 22
Dialout monitor: Sets the dialout monitor to dtr/none
Description
o
dtr
Dialout session is terminated when DTR signal on the serial port s0 toggles from High to Low
o
none
Dialout session is not dependant on the DTR signal Default: none
Modem Configuration
Connect String: Sets the Modem Connect string
Default: CONNECT
OK String: Sets the Modem OK string
Default: OK
Hangup String: Sets the Modem hang-up string
Default: +++ATH0
Ring String: Sets the Modem Ring string
Default: RING
Dial Prefix: Sets the Modem Dial-Prefix
Default: ATDT
Dial Suffix: Sets the Modem Dial-suffix
Default: ^M
Dial Number: Sets the dial-number to be dialed Default: NULL
Dialing method: Sets the modem dialing method
Description
o
Configuration method: User shall provide only the dial-number to reach
o
Chat-script method: User can write his/her own script by providing an "Expect" and a "Send" sequence
Refer to: chat-script for providing an "Expect" and a "Send" sequence
Default: configuration
Init String: Configure the Modem init strings
Init-num can range from 1-5
Chatscript
Sets/Clears expect and send strings for the chat script to act on the modem
Bridge Configuration
Bridge: Enables/disables remote transparent bridging between ethernet and serial interface. Enabling bridge will automatically enable telnet, tftp services on
the module. Disabling will automatically disable PPP on the module
Default: disable
IP Address: Sets Bridge IP address. Can be set only when Bridge is enabled
Default: Ethernet ip address
IP Mask: IP mask of the configured IP address
PPP Configuration
PPP :Enableis/Disables PPP on the serial port s0. PPP can be enabled only if bridge is enabled
Default: disable
Compression:Enables/Disables CCP compression for PPP
Default: disable
Compression Type: Sets the compression type to bsd, deflate or both
o
PPP in non raw-mode:
When "both" is configured as the compression type, the module tries to negotiate deflate first. In the event of failure, the bsd is negotiated
o
PPP in raw-mode:
Compression type "both" is not supported in raw-mode, since there is no negotiations between SocketEthernet IP Modules
Default: deflate
Raw Mode: Enables/Disables simple AHDLC framing on the Serial side. In Raw mode, no PPP negotiations are done on the serial. The ethernet data is
encapsulated with 7E delimiters. FCS is part of the AHDLC frame header
Default: disable
Authentication: Enables/Disables PPP authentication
Default: disable
Authentication Type: Sets the authentication protocol type to negotiate with the remote peer: pap/chap/pap-chap
Default: pap
Username: PPP username with which remote peer will authenticate
Default: ipmodule
Password: PPP password with which remote peer will authenticate
Default: ipmodule
(continued…)