Nortel Networks 5000i - Manual (Page 42)

Board/Connector Relationship
Figure 3-4 illustrates the relationship between PC boards{ XE "Network
installation:Board/connector relationship" } attached to the bulkhead inside the cabinet and
the connectors on the exterior surface of the cabinet in a network configuration.
MONITOR
KEYBOARD MOUSE
PRTCON
NETCOM
INPUT POWER
tiger022
LINE PRINTER
NETWORK
CAMERA
CONTROLLER
BOARD
SCANNER
CONTROLLER
MAIN BOARD
No Board Required for
Monitor (Pass Through)
KEMCON
Figure 3 – 4: Network Board/Connector Locations
Internal Cable Connections{ XE "Internal cable
connections" }
This section provides additional information regarding connection of the monitor, keyboard,
mouse, cameras, power, network, and printer (optional) cables to the appropriate connectors on
the boards located inside the scanner (Figure 3-4).
The PRTCON, NETCON, and KEMCON, boards are attached to the interior of the scanner's
bulkhead to provide an appropriate exterior connection to both standard and optional
devices.
The PC boards include the following:
• Scanner Controller main board (bed control logic).
• Camera Controller board (camera, light source, and pixel normalization logic).
• NETCON board (Network).
• KEMCON board (Keyboard and mouse).
• PRTCON board (Printer, optional).
The schematic in Figure 3-5 identifies the cable connections to the appropriate boards and the
appropriate connections of these cables to ports on the computer. The scanner is shipped with the
Page 30 5000i Scanner Installation Guide