Nortel Networks 5000i - Manual (Page 46)

Bar Code Reader
The optional Bar Code Reader { XE "Bar code installation" } is usually installed at NCS Pearson
Manufacturing. It can also be installed in the field by an NCS Pearson technician. In both cases,
the following cable connections must be performed as part of the initial installation.
There are two cables:{ XE "Bar code cabling" }
• 25-pin flat cable (I/O cable)
• 25-pin D-SUB to 9-pin D-SUB cable (Bar Code to PC cable)
The 25-pin flat cable has been pre-installed at NCS Pearson Manufacturing. You need to locate
the 9-pin D-SUB end of the Bar Code to PC cable and plug it into the Com2 serial port on the back
of the computer.
1. Ensure that the female end of the 25-pin flat cable is securely connected to the BCD board.
2. Ensure that the other end (also female) is securely connected to the 25-pin D-SUB end of the
Bar Code to PC cable.
3. Plug the 9-pin D-SUB end of the Bar Code to PC cable into the Com2 port on the back of the
computer.
Page 34 5000i Scanner Installation Guide