National Instruments Isolated Analog Output Module SCC-AO10 - Manual (Page 3)

© National Instruments Corporation 3 SCC-AO10 Isolated Analog Output Module User Guide
Note Software scaling of measurements is not supported on the Macintosh operating
system. Refer to the SCC-AO10 Connector Pin Assignments section.
You can download NI documents from ni.com/manuals . To download
the latest version of NI-DAQmx, click Download Software at ni.com .
Device Specific Information
Note For general SCC module installation and signal connection information, and
information about the SC-2345/2350 carrier, refer to the SCC Quick Start Guide, available
for download at
ni.com/manuals .
Installing the SCC-AO10
Caution Refer to the Read Me First: Safety and Radio-Frequency Interference document
before removing equipment covers or connecting/disconnecting any signal wires.
Plug the SCC-AO10 into either SC-2345/2350 analog output socket
J(X
+17), where X is 0 or 1. The SC-2345/2350 routes the voltage output of
E/M Series DAQ device analog output channel AO (X) to the SCC-AO10.
Connecting the SCC-AO10 to a Load
Caution Refer to the Read Me First: Safety and Radio-Frequency Interference document
before removing equipment covers or connecting/disconnecting any signal wires.
Note The signal names have changed. Refer to ni.com/info and enter rdtntg to
confirm the signal names.
The SCC-AO10 has a three-pin screw-terminal connector that accepts
28 to 16 AWG wires.
The screw terminals are labeled by pin numbers 1 to 3. Pin 1 is the isolated
ground. Pins 2 and 3 both connect to the isolated voltage output for
flexibility in field wiring.
Caution Connecting an external voltage source to the output terminals of the SCC-AO10
may damage the module.