NetComm NP6800 - Manual (Page 14)

www.netcomm.com.au Rev.1 - YML655
Page 14 NP6800 - Wireless LAN Access Point
Configuring the Access Point
The Access Point Utility consists of two programs, an AP Utility and an SNMP Manager,
which are used for the configuration of the NetComm NP6800 - Wireless LAN Access Point.
We recommend using the AP Utility for initial setup and configuration, with further
customisation available within the SNMP Manager to fine tune your Access Point settings.
Configuring the Access Point via USB
The AP Utility uses the USB connection to the Access Point and gives a one-screen listing of all
the settings of the Access Point.
Note: The AP Utility can only be used when the Access Point is connected via a USB
cable to your computer. If the USB cable is not connected, you will receive an error
message.
1. Open Start->Programs->802.11 Wireless LAN->Acess Point Utility and click on AP
Utility. The AP Utility screen will appear.
From this utility, the Access point can be reset or the settings may be altered or returned to
the default values. To Restore Defaults to your Access Point, click on the
Restore
Defaults button. The factory default settings of your Access Point will be restored
immediately.