NetComm NP6800 - Manual (Page 8)

www.netcomm.com.au Rev.1 - YML655
Page 8 NP6800 - Wireless LAN Access Point
Installation
Before beginning the installation, verify the hardware package contains the NetComm NP6800 -
Wireless LAN Access Point and ensure that you have the requirements listed below. Keep the
serial number in a safe place. The Support Centre uses this information to reference warranty
and service contract information.
Note: The MAC Address of the Access Point is indicated on the bottom of the case.
The NetComm NP6800 - Wireless LAN Access Point installation requires:
■ a computer with an available USB port.
■ a CD-ROM drive or Internet access.
■ Microsoft Windows 98, Millennium (ME), Windows 2000 or Windows XP
■ an ethernet cable to connect to your LAN.
Avoid exposing the NetComm NP6800 - Wireless LAN Access Point to liquids or
abrasive materials.
1. Place the NetComm NP6800 - Wireless LAN Access Point in an optimum position so that
the minimum number of obstructions such as walls, floors, ceilings, and office equipment are
between it and the nearest connecting access point or wireless device.
2. Fix the direction of the antenna. Try to place it in a position which can best cover your
wireless network. Normally, the higher you place the antenna, the better the performance
will be. The position of the antennas will enhance the receiving sensitivity.