NetComm NP6800 - Manual (Page 30)

www.netcomm.com.au Rev.1 - YML655
Page 30 NP6800 - Wireless LAN Access Point
Enable SNMP traps
Using this option you can either enable or disable SNMP traps, which are messages displayed in
the right bottom corner of the main window indicating that an action related to the AP took
place. Permitted messages are:
Trap Reassociation: This trap message is sent when a Station’s reassociation request
is received from the AP - Bridge.
Trap Association: Indicates the reception of an association request packet.
Trap Disassociation: This trap message is sent when a disassociation notification
packet is received from a station.
Trap Reset: This trap message is sent when the AP resets.
Trap Setting IP with Ping: This trap message is sent when the APBridge IP Address is set
with the transmission of a ping message.
Trap Start Up: This trap message is sent when the AP starts up.